High Priority Symbology; Low Priority Symbology; Preferred Symbology Time-Out; Preferred Symbology Default - Honeywell Vuquest 3320g User Manual

High Priority Symbology

To specify the high priority symbology, scan the High Priority Symbology bar code below. On the
page A-1, find the symbology you want to set as high priority. Locate the Hex value for that symbology and scan the 2 digit
hex value from the Programming Chart (inside back cover). Scan Save to save your selection. Default = None

Low Priority Symbology

To specify the low priority symbology, scan the Low Priority Symbology bar code below. On the
A-1, find the symbology you want to set as low priority. Locate the Hex value for that symbology and scan the 2 digit hex
value from the Programming Chart (inside back cover).
If you want to set additional low priority symbologies, scan FF, then scan the 2 digit hex value from the Programming Chart
for the next symbology. You can program up to 5 low priority symbologies. Scan Save to save your selection. Default =
None.

Preferred Symbology Time-out

Once you have enabled Preferred Symbology and entered the high and low priority symbologies, you must set the time-out
period. This is the period of time the scanner will search for a high priority bar code after a low priority bar code has been
encountered. Scan the bar code below, then set the delay (from 1-3,000 milliseconds) by scanning digits from the inside
back cover, then scanning Save. Default = 500 ms.

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their default values.

Output Sequence Overview

Output Sequence Editor

This programming selection allows you to program the scanner to output data (when scanning more than one symbol) in
whatever order your application requires, regardless of the order in which the bar codes are scanned. Reading the Default
Sequence symbol programs the scanner to the Universal values, shown below. These are the defaults. Be certain you
want to delete or clear all formats before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the code I.D., code length, and character match(es)
your application requires. Use the Alphanumeric symbols (inside back cover) to read these options. You must hold
the button while reading each bar code in the sequence.
3 - 16
High Priority Symbology
Low Priority Symbology
Preferred Symbology Time-out
Preferred Symbology Default
Symbology Charts on
Symbology Charts on page