Output Sequence Overview; Output Sequence Editor; To Add An Output Sequence - Honeywell HH1800 User Manual

Output Sequence Overview

Output Sequence Editor

This programming selection allows you to program the scanner to output data (when
scanning more than one symbol) in whatever order your application requires, regardless of
the order in which the barcodes are scanned. You can define up to 15 barcodes in an output
sequence.
Note: To make Output Sequence Editor selections, you'll need to know the code I.D., code length,
and character match(es) your application requires. Use the alphanumeric symbols from the
Programming Chart,
barcode in the sequence.

To Add an Output Sequence

An output sequence is created using a string of serial commands that is sent to the scanner.
This string is most easily sent to the scanner using the EZConfig software tool (see
for Scanning Introduction
alphanumeric barcodes (see the
1.
2.
3.
4.
42
beginning on page 211. You must hold the trigger while reading each
on page 159). You can also accomplish this by scanning
If you are using barcodes to create your output sequence, scan
on page 45.
Code I.D.
On the Symbology Charts
the output sequence format. Make a note of the hex value for that symbology. If you are
using barcodes to create your output sequence, scan the 2 digit hex value from the
Programming Chart, beginning on page 211.
Length
Specify what length (up to 9999 characters) of data output will be acceptable for this
symbology. Make a note of the length. If you are using barcodes to create your output
sequence, scan the 4 digit data length
(Note: 50 characters is entered as 0050. 9999 is a universal number, indicating all
lengths.) When calculating the length, you must count any programmed prefixes,
suffixes, or formatted characters as part of the length (unless using 9999).
Character Match Sequences
On the ASCII Conversion Chart (Code Page
represents the character(s) you want to match. Make a note of the hex value for the
character(s). If you are using barcodes to create your output sequence, use the
Programming Chart, beginning on page 211 to read the alphanumeric combination that
Programming Chart, beginning on page 211).
on page 200, find the symbology to which you want to apply
Programming Chart,
1252), page 203, find the hex value that
EZConfig
Enter Output Sequence
beginning on page 211.
HH1800 User Guide