Table of Contents
Advertisement
Timeout Retries
This setting limits the number of Communication Timeout retries. If
the Timeout Retries is set to 0, the transmission is terminated after
the ini-tial Communication Timeout. Scan the bar code below, then
set the number of retries (from 0-255) by scanning digits from the
Programming
ting.) Default = 0.
Communication Timeout Beeper
This selection programs the engine to issue an error beep when a
communication timeout has occurred. The error beep sound is pro-
grammed using
NAK Retries
This selection limits the number of NAK retries that can occur in ACK/NAK
mode. Scan the bar code below, then set the number of retries (from 0-
255) by scanning digits from the
Save. (5 is the recommended setting.) Default = 0, or disabled.
Chart, then scanning Save. (5 is the recommended set-
Timeout Retries
Number of Beeps – Error
Off
Programming
NAK Retries
(page 3-4). Default = On.
* On
Chart, then scanning
2-21
Advertisement
Table of Contents
