Move Commands - Honeywell N431X User Manual

F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as: 1234567890**ABCDEFGHIJ
Insert symbology name
B3 Insert the name of the bar code's symbology in the output message,
without moving the cursor. Only symbologies with a Honeywell ID are
included (see
Conversion Chart,
character codes.
Insert bar code length
B4 Insert the bar code's length in the output message, without moving
the cursor. The length is expressed as a numeric string and does not
include leading zeroes.
B3 and B4 Example: Insert the symbology name and length
Send the symbology name and length before the bar code data from
the bar code above. Break up these insertions with spaces. End with
a carriage return.
Command string: B3F42001B4F42001F10D
B3 is the "Insert symbology name" command
F4 is the "Insert a character multiple times" command
20 is the hex value for a space
01 is the number of time the space character is sent
B4 is the "Insert bar code length" command
F4 is the "Insert a character multiple times" command
20 is the hex value for a space
01 is the number of time the space character is sent
F1 is the "Send all characters" command
0D is the hex value for a CR
The data is output as: Code128 20 1234567890ABCDEFGHIJ

Move Commands

Move the cursor forward a number of characters
F5 Move the cursor ahead "nn" characters from current cursor position.
Syntax = F5nn where nn is the numeric value (00-99) for the number
of characters the cursor should be moved ahead.
5 - 8
<CR>
Symbology Charts
beginning on page A-3 for decimal, hex and
<CR>
on page A-1). Refer to the ASCII