Table of Contents
Advertisement
you are programming. (See
5-17 for further information.)
Step 3. Terminal Type
Refer to
number for your PC. Scan three numeric bar codes on the inside back
cover to program the engine for your terminal ID (you must enter 3
digits). For example, scan 0 0 3 for an AT wedge.
Note: 099 indicates all terminal types.
Step 4. Code I.D.
In the
Symbology Charts,
to which you want to apply the data format. Locate the Hex value for
that symbology and scan the 2 digit hex value from the
Chart
inside the back cover of this manual.
If you wish to create a data format for all symbologies, with the
excep-tion of some specific
If you are creating a data format for Batch Mode Quantity, use 35
for the Code I.D.
Note: 99 indicates all symbologies.
Step 5. Length
Specify what length (up to 9999 characters) of data will be acceptable
for this symbology. Scan the four digit data length from the
Programming Chart
example, 50 characters is entered as 0050.
Note: 9999 indicates all lengths.
Step 6. Editor Commands
Refer to
that represent the command you want to enter. 94 alphanumeric
characters may be entered for each symbology data format.
Step 7. Scan Save to save your data format, or Discard to exit without saving
your changes.
5 - 2
Terminal ID Table
inside the back cover of this manual. For
Data Format Editor Commands
Primary/Alternate Data Formats
(page 5-4) and locate the Terminal ID
beginning on page A-1, find the symbology
symbologies, refer to B8
(page 5-4). Scan the symbols
on page
Programming
(page
5-15).
Advertisement
Table of Contents
