Table of Contents
Advertisement
Centering
Use Centering to narrow the engine's field of view to make sure the engine
reads only those bar codes intended by the user. For instance, if multiple
codes are placed closely together, centering will insure that only the desired
codes are read.
Scan Centering On, then scan one of the following bar codes to change the
left or right of the centering window. To set the the percent you want to shift
the centering window scan the digits from the
Programming
Chart, then
scanning Save. Default = 40% Left and 60% Right.
Note: Centering is dependent on the orientation of the engine. If the engine is
inverted, right becomes left and left becomes right.
Centering On
* Centering Off
Left of Centering Window
Right of Centering Window
Blinky Mode
Blinky Mode can be activated by Object Detection or the External Trigger.
When the Blinky Mode On or Blinky Always On/Continuous bar codes are
scanned, the scan engine blinks on and off at 50% duty cycle (250
milliseconds on, then 250 milliseconds off.) Default = Blinky Mode Off.
* Blinky Mode Off
Blinky Mode On
Blinky Always On/Continuous
3-13
Advertisement
Table of Contents
