Ruby Terminal Default Settings; Gilbarco Terminal Default Settings - Honeywell N431X User Manual

®
Verifone
Scan the following Plug and Play code to program the engine for a Verifone Ruby
terminal. This bar code sets the baud rate to 1200 bps and the data for-mat to 8
data bits, Mark parity, 1 stop bit and RTS/CTS no timeout. It also adds a line feed
(LF) suffix and programs the following prefixes for each symbology:
Note: If you are having unexpected results with this programming code, scan
the Activate Defaults
programming code above.
®
Gilbarco
Scan the following Plug and Play code to program the engine for a Gilbarco
ter-minal. This bar code sets the baud rate to 2400 bps and the data format to
7 data bits, even parity, 2 stop bits. It also adds a carriage return (CR) suffix
and programs the following prefixes for each symbology:
Note: If you are having unexpected results with this programming code, scan
the Activate Defaults
programming code above.
2 - 8

Ruby Terminal Default Settings

Symbology
UPC-A
UPC-E
EAN-8
EAN-13
Verifone Ruby Settings
bar code on page 1-5 first, then scan the
Terminal Default Settings
Symbology
UPC-A
UPC-E
EAN-8
EAN-13
Gilbarco Settings
bar code on page 1-5 first, then scan the
Prefix
A
A
FF
F
Prefix
A
E0
FF
F