Diagnostics; Test Inputs And Outputs; Figure 45: Test Inputs And Outputs - WAGO -TO-PASS 761 Manual

106

Diagnostics

9 Diagnostics
9.1

Test Inputs and Outputs

To test the inputs and outputs select the menu option Controller > Test I/O.
The following window is displayed:

Figure 45: Test inputs and outputs

The process values of the inputs are displayed in the upper area and the process
values of the outputs are displayed in the lower area.
By pressing the buttons [Output 1] ... [Output 4] in the upper area switch digital
inputs on and off.
A value range of 0 mA ... 20 mA and 4 mA ... 20 mA is defined for the analog
outputs. No decimal places can be entered.
Enter the required numerical value and click the [Set] button to set the analog
outputs.
Once the output has been set, the imported value is normalized with decimal
places.
Click [OK] to end the test and close the window.
Alternatively, the inputs and outputs can also be tested with the help of the menu
option Visualization > Process values.
761-217 Telecontrol Module Compact, 8 AI, Web, MODBUS485
WAGO-TO-PASS® 761
Manual
Version 1.0.0