WAGO-TO-PASS® 761
761-217 Telecontrol Module Compact, 8 AI, Web, MODBUS485
The counter status shows the last change that has occurred since the last value
script transmission, or after a system start (independent of the SMS and logger
status).
The counter values are indicated as hexadecimal values (as are the MODBUS
values).
Alarms can have the following statuses:
Table 53: Alarm status
Status Explanation
0
1
2
If both values are reached simultaneously, only status "2" is transmitted.
&SQ: Signal quality or modem connection (without formatting):
Table 54: Signal quality (from AT Reference Guide by Telit)
Value
0
1
2 ... 30 (-109)dBm ... (-53)dBm / 2 dBm per stage
31
99
&MV: Transmission is performed only up to the last configured register (module
address not 0).
If registers were not previously parameterized (module address = 0), these will be
marked as "ZERO".
If errors occurred during register querying, these will be flagged with "ERRO".
Manual
Version 1.0.0
No alarm
First value reached/transgressed
Second value reached/transgressed
Quality
(-113) dBm or less
(-111) dBm
(-51)dBm or greater
Unknown or cannot be measured
WAGO TO-PASS® Web
119