Counters; Figure 44: Counter Process Values - WAGO -TO-PASS 761 Manual

100 Operation
8.2.2.2

Counters

To display the counter process values, click the [Counter] button (possible only
when inputs have been configured as counters). The process values displayed are
valid when the on-line indicator is highlighted in green.

Figure 44: Counter process values

The counter statuses are shown at the top of the window, while the counter values,
the starting and end values and the limits are shown at the bottom.
To start a counter, click the button [Activate].
To stop a counter, click the button [Deactivate].
To restore the counter to its starting value, click the button [Reset].
To set a counter to a new value, enter the required counter value in the
corresponding input field and then click the associated button [Set] to apply the
new value.
761-217 Telecontrol Module Compact, 8 AI, Web, MODBUS485
WAGO-TO-PASS® 761
Manual
Version 1.0.0