Analog Outputs; Figure 32: Configuring The Analog Outputs; Table 34: Configuring The Analog Outputs - WAGO -TO-PASS 761 Manual

72 Parameterizing
7.5.5

Analog Outputs

Select your TO-PASS
using the identifier. Select the output to be configured under Analog Outputs.
The parameters of the output are given on the right side.
The buttons and input fields are identical for all analog outputs:

Figure 32: Configuring the analog outputs

Table 34: Configuring the analog outputs

Standardization
Output Signal
Min. value
Max. value
Unit
Set output
Text
761-217 Telecontrol Module Compact, 8 AI, Web, MODBUS485
®
telecontrol module from the left side of the project tree
Use these buttons to select the output signal for the actuator
connected to the TO-PASS
In this field enter the starting value from which the output
value is normalized. This value corresponds to the minimum
output current value of 0 mA or 4 mA.
In this field enter the end value up to which the output value
is normalized. This value corresponds to the maximum output
current 20 mA.
In this field enter the unit with a maximum of 5 characters
with which the normalized process value is to be transmitted.
In this field enter the text for setting the output.
If this text is transmitted with a value situated within the min.
and max. value, the TO-PASS
analog output to the specified value.
WAGO-TO-PASS® 761
®
telecontrol module.
®
telecontrol module sets the
Manual
Version 1.0.0