Number Of Beeps - Base Error; Scanner Report; Scanner Address; Base Address - Honeywell Xenon Series User Manual

Number of Beeps - Base Error

The number of beeps and LED flashes emitted by the base for an error condition
can be programmed from 1 - 9. For example, if you program this option to have five
error beeps, there will be five error beeps and five LED flashes in response to an
error. To change the number of error beeps, scan the bar code below and then scan
a digit (1-9) from the
Default = 1.

Scanner Report

Scan the bar code below to generate a report for the connected scanner. The report
indicates the port, scanner name, and address. To assign a name to your scanner,
refer to

Scanner Address

Scan the bar code below to determine the address of the scanner you are using.

Base Address

Scan the bar code below to determine the address of the base you are using.
94
Programming Chart,
Number of Base Error Beeps/LED Flashes
Menu Command Syntax, page 267.
beginning on page 353, then Save.
Scanner Report
Scanner Address
Base Address
Xenon/Granit User Guide