Unlink The Scanner - Honeywell Xenon Series User Manual

Locked Link Mode - Single Scanner
If you link a scanner to a base using the Locked Link Mode, other scanners are
blocked from being linked if they are inadvertently placed into the base. If you do
place a different scanner into a base, it will charge the scanner, but the scanner will
not be linked.
To use a different scanner, you need to unlink the original scanner by scanning the
Unlink Scanner bar code. (See
Open Link Mode - Single Scanner
When newly shipped or defaulted to factory settings, a scanner is not linked to a
base. A link is established when the scanner is placed into a base. When in Open
Link Mode, a new link is established when a new scanner is placed in the base.
Each time a scanner is placed into a base, the scanner becomes linked to the base
and the old scanner is unlinked.

Unlink the Scanner

If a base has a scanner linked to it, that scanner must be unlinked before a new
scanner can be linked. Once the previous scanner is unlinked, it will no longer com-
municate with the base. To unlink the scanner from a base, scan the Unlink Scan-
ner bar code below.
96
Locked Link Mode
(Single Scanner)
Scanner Modes, page 95.)
* Open Link Mode
(Single Scanner)
Unlink Scanner
Xenon/Granit User Guide