Honeywell Xenon Series User Manual page 228

UPC-A Addenda Required
When Required is scanned, the scanner will only read UPC-A bar codes that have
addenda. You must then turn on a 2 or 5 digit addenda listed on
Default = Not Required.
Addenda Timeout
You can set a time during which the scanner looks for an addenda. If an addenda is
not found within this time period, the data can be either transmitted or discarded,
based on the setting you are using for
milliseconds) for this timeout by scanning the bar code below, then setting the tim-
eout (from 0-120 milliseconds) by scanning digits from the
beginning on page 353 of this manual, then Save. Default = 500.
Note: The Addenda Timeout setting is applied to all addenda and coupon code searches.
UPC-A Addenda Separator
When this feature is On, there is a space between the data from the bar code and
the data from the addenda. When turned Off, there is no space. Default = On.
208
Required
Addenda Timeout
* On
UPC-A Addenda Required. Set the length (in
Xenon/Granit User Guide
page 207.
* Not Required
Programming Chart,
Off