User Specified Intercharacter Delay; Interfunction Delay - Honeywell Xenon Series User Manual

To remove this delay, scan the Intercharacter Delay bar code, then set the number
of delays to 0. Scan the Save bar code from the
page 353.
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length bar code below, then scan the number of 5ms delays from the
Programming Chart,
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a
printable character to trigger the delay (see
343.
To remove this delay, scan the Delay Length bar code, and set the number of
delays to 0. Scan the Save bar code from the
page 353.

Interfunction Delay

An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each control character in the message string.
Scan the Interfunction Delay bar code below, then scan the number of 5ms
delays, and the Save bar code from the
353.
Xenon/Granit User Guide
beginning on page 353, then Save.
)
Delay Length
Lower ASCII Reference
Programming Chart,
Programming Chart,
Prefix Scanned Data
STX 1 HT 2 3 4 5
Interfunction Delays
Interfunction Delay
Programming Chart,
Character to Trigger Delay
beginning on
beginning on page
Suffix
CR LF
beginning on
Table, page
165