Reread Delay; User-Specified Reread Delay - Honeywell Xenon Series User Manual

Reread Delay

This sets the time period before the scanner can read the same bar code a second
time. Setting a reread delay protects against accidental rereads of the same bar
code. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive bar code scanning is required. Reread Delay
only works when in a

User-Specified Reread Delay

If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart,
2D Reread Delay
Sometimes 2D bar codes can take longer to read than other bar codes. If you wish
to set a separate Reread Delay for 2D bar codes, scan one of the programming
codes that follows. 2D Reread Delay Off indicates that the time set for
Delay
Xenon/Granit User Guide
Presentation Mode
Short (500 ms)
Long (1000 ms)
beginning on page 353, then Save.
is used for both 1D and 2D bar codes. Default = 2D Reread Delay Off.
* 2D Reread Delay Off
(see page 122). Default = Medium.
User-Specified Reread Delay
* Medium (750 ms)
Extra Long (2000 ms)
Reread
129