Error Indicators; Beeper Pitch - Base Error; Number Of Beeps - Base Error; Scanner Report - Honeywell Xenon 1900 User Manual

High (4200 Hz)

Error Indicators

Beeper Pitch - Base Error

Note: This feature only applies to the CCB01-010BT base.
The CCB01-010BT base can be configured to beep at a particular pitch when an error occurs, such as transmission prob-
lems to a host system. The beeper pitch codes modify the pitch (frequency) of the error tone the base emits when there is
an error. Default = Low.
* Razz (250 Hz)
High (4200 Hz)

Number of Beeps - Base Error

Note: This feature only applies to the CCB01-010BT base.
The number of beeps and LED flashes emitted by the CCB01-010BT base for an error condition can be programmed from
1 - 9. For example, if you program this option to have five error beeps, there will be five error beeps and five LED flashes in
response to an error. To change the number of error beeps, scan the bar code below and then scan a digit (1-9) bar code
and the Save bar code on the

Scanner Report

Scan the bar code below to generate a report for the connected scanners. The report indicates the port, work group, scanner
name, and address. To assign a name to your scanner, refer to
3 - 8
Programming Chart inside the back cover of this manual. Default = 1.
Number of Base Error Beeps/LED Flashes
Scanner Report
Menu Command Syntax, page 11-1.
Medium (3250 Hz)