Table of Contents
Advertisement
CHAPTER
6
HEALTHCARE SETTINGS
The following settings have been developed to enhance scanning in a healthcare
environment. These settings are only supported by the Xenon 1900h scanner and
Xenon 1902h scanner and base. They allow you to set quickly configure streaming
presentation, and to set the scanner and base to quiet modes for scanning that do
not disturb resting patients.
Quiet Operations - Combination Codes
The following combination codes program your Xenon healthcare scanner and
base for silent or quiet settings using a single programming code. If you wish to
program some of these quiet settings individually, refer to
and Volume Settings,
Silent Mode with Flashing LED
Scan the following bar code to completely silence the Xenon 1900h scanner or
Xenon 1902h scanner and base. The scanner beep, base beep, base and scanner
power up beep, and scanner linking sounds are all silenced. When a bar code is
scanned, the LED and aimer flash 5 times. Green indicates a good scan, red indi-
cates a bad scan.
Silent Mode with Flashing LED -
Cordless Scanner and Base
Xenon/Granit User Guide
beginning on page 151.
Quiet Operations - LED
Silent Mode with Flashing LED -
Corded Scanner
149
Advertisement
Table of Contents
