Low Power Alert Beep; Base; Base Communication And Scanning - Honeywell Xenon Series User Manual

Interval Between Alerts
If you have set the
the length of time, in seconds, between the low power alerts. To set this interval,
scan the bar code below and then scan a digit (10-120) bar code from the
Programming Chart,
between alerts.

Low Power Alert Beep

If you do not want the beeper to sound for a low power alert, scan the Low Power
Alert Beep Off bar code. Any low power alert settings will still flash the scanner
LEDs, whether or not the beeper sounds. Default = Low Power Alert Beep On.

Base

The base contains colored LEDs that indicate the status of the unit, verifies its
communication with the host system, and indicates scanner instant charge pack
condition.

Base Communication and Scanning

The following feedback is provided by the base and indicates communication and
scanning status.
Red LED - Host Communication
Red LED
Off
On continuously
Short blinks in multiple pulses. Occurs while transferring
data to/from the RF module or the host port.
88
Low Power Alert Repeat
beginning on page 353, then Save. Default = 10 seconds
Low Power Alert Beep Off
(page 87) to more than 1, you can set
Interval Between Alerts
Communication
Condition
USB suspend
Host communication
available
Receiving/sending data
*Low Power Alert Beep On
Xenon/Granit User Guide