Error Indicators; Beeper Pitch - Base Error; Number Of Beeps - Base Error; Scanner Report - Honeywell Xenon 1900 User Manual

Error Indicators

Beeper Pitch - Base Error

The base can be configured to beep at a particular pitch when an error
occurs, such as transmission problems to a host system. The beeper pitch
codes modify the pitch (frequency) of the error tone the base emits when
there is an error. Default = Low.
* Razz (250 Hz)
High (4200 Hz)

Number of Beeps - Base Error

The number of beeps and LED flashes emitted by the base for an error
condition can be programmed from 1 - 9. For example, if you program this
option to have five error beeps, there will be five error beeps and five LED
flashes in response to an error. To change the number of error beeps, scan
the bar code below and then scan a digit (1-9) bar code and the Save bar
code on the
Default = 1.

Scanner Report

Scan the bar code below to generate a report for the connected scanners. The
report indicates the port, work group, scanner name, and address. To assign a
name to your scanner, refer to
Programming Chart
Number of Base Error Beeps/LED Flashes
Menu Command
Scanner Report
Medium (3250 Hz)
inside the back cover of this manual.
Syntax, page 11-1.
3 - 9