Honeywell Xenon Series User Manual page 23

2. If you are connecting a Granit scanner, make sure the cable is pushed tightly
Note: The power supply must be ordered separately, if needed.
3. If you are connecting a CCB01-010BT or CCB01-010BT-07N-BF Base, make
4. The scanner beeps.
5. Verify the scanner or cordless base operation by scanning a bar code from the
Xenon/Granit User Guide
into the scanner. Loosen the locking plate and slide it over the base of the cable
connector to lock the cable in place. Tighten the screw.
CCB01-010BT/CCB01-010BT-07N-BF Base USB Connection:
CCB02-100BT/CCB05-100BT Base USB Connection:
sure the cables are secured in the wireways in the bottom of the cordless base
and the base sits flat on a horizontal surface. If you are connecting a CCB02-
100BT or CCB05-100BT Base, see
Base on page 10.
Sample Symbols, beginning on page 351.
Mount a CCB02-100BT/CCB05-100BT
3