Honeywell Xenon Series User Manual page 28

3. If you are connecting a Granit scanner, make sure the cable is pushed tightly
Note: The power supply must be ordered separately, if needed.
4. If you are connecting a CCB01-010BTor CCB01-010BT-07N-BF Base, make
5. Plug the serial connector into the serial port on your computer. Tighten the two
6. Once the scanner or cordless base has been fully connected, power up the
This interface programs 115,200 baud, 8 data bits, no parity, and 1 stop bit.
8
into the scanner. Loosen the locking plate and slide it over the base of the cable
connector to lock the cable in place. Tighten the screw.
CCB01-010BT/CCB01-010BT-07N-BF Base RS232 Serial Port Connection:
CCB02-100BT/CCB05/100BT Base RS232 Serial Port Connection:
sure the cables are secured in the wireways in the bottom of the cordless base
and the base sits flat on a horizontal surface. If you are connecting a CCB02-
100BT or CCB05-100BT Base, see
Base on page 10.
screws to secure the connector to the port.
computer.
Mount a CCB02-100BT/CCB05-100BT
Xenon/Granit User Guide