Honeywell Xenon Series User Manual page 212

When Check Character is set to Validate and Transmit, the scanner only reads
Code 39 bar codes printed with a check character, and will transmit this character
at the end of the scanned data. Default = No Check Character.
Code 39 Message Length
Scan the bar codes below to change the message length. Refer to
Description
lengths = 0-48. Minimum Default = 0, Maximum Default = 48.
Minimum Message Length
Code 39 Append
This function allows the scanner to append the data from several Code 39 bar
codes together before transmitting them to the host computer. When the scanner
encounters a Code 39 bar code with the append trigger character(s), it buffers
Code 39 bar codes until it reads a Code 39 bar code that does not have the append
trigger. The data is then transmitted in the order in which the bar codes were read
(FIFO). Default = Off.
192
* No Check Character
Validate and Transmit
(page 188) for additional information. Minimum and Maximum
On
Validate, but Don't Transmit
Message Length
Maximum Message Length
* Off
Xenon/Granit User Guide