Honeywell Xenon Series User Manual page 353

Replace a Xenon Interface Cable
1. Turn off the power to the host system.
2. Disconnect the scanner's cable from the terminal
3. Locate the small hole on the back of the scanner's
4. Straighten one end of a paper clip.
5. Insert the end of the paper clip into the small hole
6. Replace with the new cable.
Replace a Granit Interface Cable
1. Turn the power to the host system OFF.
2. Disconnect the scanner's cable from the terminal or
3. Unscrew the locking plate on the bottom of the
4. Slide the locking plate away from the connector and
5. Replace with the new cable.
6. Slide the locking plate over the base of the connector
Replace Cables and Batteries in Cordless Systems
Replace an Interface Cable in a Base
1. Turn the power to the host system OFF.
2. Disconnect the base's cable from the terminal or computer.
Xenon/Granit User Guide
or computer.
handle. This is the cable release.
and press in. This depresses the retention tab,
releasing the connector. Pull the connector out
while maintaining pressure on the paper clip, then
remove the paper clip.
Insert the connector into the opening and press firmly. The connector is keyed
to go in only one way, and will click into place.
computer.
scanner.
pull the cable out of the scanner.
Insert the connector into the opening and press firmly.
to secure the cable, and screw the plate into place.
Cable
Release
333