Connect With Rs485 - Honeywell Xenon Series User Manual

Connect with RS485

A Xenon scanner or cordless base can be connected for an IBM POS terminal inter-
face. (This interface is not available in the Granit devices.)
1. Connect the appropriate interface cable to the device, then to the computer.
Note: The power supply must be ordered separately, if needed.
2. Make sure the cables are secured in the wireways in the bottom of the cordless
3. Turn the terminal/computer power back on. The scanner beeps.
4. Verify the scanner or cordless base operation by scanning a bar code from the
For further RS485 settings, refer to RS485, page 18.
Xenon/Granit User Guide
Corded Xenon Scanner RS485 Connection:
/
CCB01-010BT CCB01-010BT-07N-BF Base RS485 Connection:
base and the base sits flat on a horizontal surface.
Sample Symbols, beginning on page 351. The scanner beeps once. If using a
Granit scanner, it also vibrates.
9