Table of Contents
Advertisement
Auto Reconnect Mode
Auto Reconnect controls whether or not the scanner automatically begins the
relink process when a loss of connection is detected. When the Auto Reconnect On
bar code is scanned, the scanner begins the relink process immediately, without
user intervention. Default = Auto Reconnect On.
The table below shows the results of the Auto Reconnect On and Off settings:
Event
Scanner out of range
Base reset (firmware
upgrade or power cycle)
Scanner power down due to
Power Time-Out Timer
setting
Scanner reset due to
firmware upgrade
Scanner reset due to instant
charge pack change
Scanner placed in different
base unit
Maximum Link Attempts
The Maximum Link Attempts setting controls the number of times the scanner
tries to form a connection with a base. During the connection setup process, the
scanner transmits in order to search for and connect to a base. In order to prevent
continuous transmissions that could interfere with other users of the ISM band,
the number of attempts to connect is limited by this setting. After the maximum
108
* Auto Reconnect On
Auto Reconnect On
Relink occurs automatically. If
maximum number of link attempts
is unsuccessful, then the scanner
must be relinked by either pulling
the trigger or placing the scanner
in the base. (See
Maximum Link
Attempts
on page 108.)
Scanner behaves as if out of range.
Trigger must be pulled or the scanner must be placed in the base unit
to relink.
(Note: scanner relinks on power up, but powers on due to one of the
above actions.)
Relink occurs automatically.
Relink occurs automatically.
Relink to new base occurs automatically.
Auto Reconnect Off
Auto Reconnect Off
The scanner is relinked by
pulling the trigger.
No attempt to relink made
while base is powered off.
Trigger must be pulled to
initiate relinking.
Xenon/Granit User Guide
Advertisement
Table of Contents
