Primary/Alternate Data Formats; Single Scan Data Format Change - Honeywell Xenon Series User Manual

Primary/Alternate Data Formats

You can save up to four data formats, and switch between these formats. Your pri-
mary data format is saved under 0. Your other three formats are saved under 1, 2,
and 3. To set your device to use one of these formats, scan one of the bar codes
below.

Single Scan Data Format Change

You can also switch between data formats for a single scan. The next bar code is
scanned using an alternate data format, then reverts to the format you have
selected above (either Primary, 1, 2, or 3).
For example, you may have set your device to the data format you saved as Data
Format 3. You can switch to Data Format 1 for a single trigger pull by scanning the
Single Scan-Data Format 1 bar code below. The next bar code that is scanned
uses Data Format 1, then reverts back to Data Format 3.
Xenon/Granit User Guide
Primary Data Format
Data Format 2
Single Scan-Primary
Data Format
Data Format Non-Match
Error Tone Off
Data Format 1
Data Format 3
185