Override Locked Scanner; Out-Of-Range Alarm; Alarm Sound Type - Honeywell Xenon Series User Manual

Override Locked Scanner

If you need to replace a broken or lost scanner that is linked to a base, scan the
Override Locked Scanner bar code below with a new scanner and place that scan-
ner in the base. The locked link is overridden, the broken or lost scanner's link with
the base is removed, and the new scanner is linked to the base.

Out-of-Range Alarm

If your scanner is out range of the base, an alarm sounds from both your base and
scanner. The alarm stops when the scanner is moved closer to the base, when the
base connects to another scanner, or when the alarm duration expires. To activate
the alarm options for the scanner or the base and to set the alarm duration, scan
the appropriate bar code below and then set the time-out duration (from 0-3000
seconds) by scanning digits on the
then Save.
Note: If you are out of range when you scan a bar code, you will receive an error tone even if
you do not have the alarm set. You receive the error tone since the data could not be
communicated to the base or the host.

Alarm Sound Type

You may change the alarm type for the scanner or a base by scanning the appropri-
ate bar code below and then scanning a digit (0-7) bar code from the
Chart,
The sounds are as follows:
Setting
0
1
2
Xenon/Granit User Guide
Base Alarm Duration
beginning on page 353, then Save. Default = 0.
Sound
3 long beeps, medium pitch
3 long beeps, high pitch
4 short beeps, medium pitch
Override Locked Scanner
(Single Scanner)
Programming Chart, beginning on page 353,
Scanner Alarm Duration
Programming
97