Cassette Tape Manual Ejection - Sony HDCAM HDW-F900 Maintenance Manual

2-7. Cassette Tape Manual Ejection

2-7. Cassette Tape Manual Ejection
1. Turn off the power switch.
2. Open the cover of the outside panel shown in the
figure.
3. While pushing the gear inside using a Phillips screw-
driver, turn the gear counterclockwise until the front
lid lock gets released.
4. The front lid opens and the cassette tape can be
ejected.
Front lid
n
Do not turn the gear after the front lid lock was released.
Closing the front lid
The front lid cannot be closed and locked in the above
status.
Perform either step below to close and lock the front lid.
(1) Turn on the power switch.
(2) Turn the gear slightly clockwise.
2-20
If the left mentioned operations are disabled, perform the
following procedures.
1. Remove the front lid and outside panel.
2. Disconnect the antenna flexible board from the
3. Extract the antenna flexible board from the gap
4. Remove the DC-DC converter in the arrow direction.
Connector
Outside
panel
Cover
1
2
Turn while pushing
(Counterclockwise)
5. With the lid of the cassette tape raised, raise the white
6. Remove the cassette tape carefully preventing damage.
n
When installing the DC-DC converter, use care about its
position and direction, and insert the RE-140 board along
the groove of the chassis.
(Refer to Section 2-4.)
n
Even a slight bend causes a short life of the flexible
board, therefore use extreme care to handle it.
connector of the CCM-33B board.
between the shield case and the shield plate. (Refer to
Figure 1.)
DC-DC converter
Antenna
flexible board
CCM-33B
board
Cassette
compartment
Connectors of
MB-877 board
lock roller of the cassette compartment to set it to the
raised status. (For details of how to raise the cassette
compartment, refer to Section 2-6.)
Antenna flexible board
Shield case
Shield plate
Figure 1
RE-140 board
Groove
HDW-F900 P1