Software Description; Starting/Exiting Pannoramic® Scanner Software For Research; Starting The Control Software; Exiting Pannoramic® Scanner Software For Research Control Software - 3D Histech PANNORAMIC SCAN RX User Manual

PANNORAMIC® SCAN RX 1.0

4 Software Description

4.1 Starting/Exiting Pannoramic® Scanner Software for Research

4.1.1 Starting the Control Software

To start the program, double-click on the program icon on the desktop.
Before software initialization the user interface is opened, and the mode selection icons are
displayed. These three buttons represent Microscope and Planner scanner modes, and the
Service mode. After selecting the required mode, the main window is displayed.
Microscope mode
•
for digitization of individual slide or individual rack
•
set scanning profile of the slide
•
use Live microscope
Planner mode
•
plan the entire scanning procedure
•
assign one or more profiles to each slide
•
define Brightfield and Fluorescence or mixed scanning mode within a run
•
define scanning profile to slides included in racks or magazines
•
automated scanning mode
Service mode
•
Service password
•
Camera settings
•
Image compensation
•
Barcode settings
•
Microscope control
4.1.2 Exiting Pannoramic® Scanner Software for Research control software
To exit the software, Click X at the main window header to close the program. Note, that
when exiting the software, the loaded slide will be automatically unloaded.
MAY 13, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
Figure 11. Mode selection window
SOFTWARE DESCRIPTION
36