3D Histech PANNORAMIC SCAN RX User Manual page 96

PANNORAMIC® SCAN RX 1.0
These areas are digitized based on user settings (for example, Fill holes in scan
area) and not detected by the selected threshold value.
These areas are digitized. They are detected based on the selected threshold
value.
These areas are not digitized based on their position (for example, they are
outside the selection box). They are detected by the selected threshold value.
If Scan area inside the marker is selected in the Preview panel, the preview
camera detects the marker pen. The inside areas appear in red color and will
be digitized.
This color is only displayed during scanning.
All the layers will be hidden / existing but not visible. The original preview
image is shown but layer information is still valid. Note, that while this function
is active, none of the other preview functions can be selected.
NOTE: If all layers are hidden, the scanning selection is not visible.
Discrete sample areas will be scanned separately as individual slides. If there
are two samples on a slide, two separate virtual slides will be created. NOTE:
Discrete areas are numbered in the preview window. You can select up to 650
discrete areas. All discrete areas are scanned, please make sure to activate the
Remove specks function.
MAY 13, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
Areas that will be scanned
Detected sample areas that will be scanned
Detected sample areas that will not be scanned
Marker
Areas scanned in
Hide all layers
Separate scanning
Show pre-scans pseudo-colorized
SCANNING MODES AND SETTINGS
95