3D Histech PANNORAMIC SCAN RX User Manual page 85

PANNORAMIC® SCAN RX 1.0
Scan settings
•
Change filters after whole slide scanning
To optimize speed, filter change should take place after the digitization of the slide with
one channel.
•
Change filters at each field-of-view
Filters should be changed for each field of view if very precise colocalization is required
but consider that this option is more time consuming.
Notice:
Make sure to select the Change filters at each field of view option if using multi band filter
for multi-channel digitization.
Caution!
If the specimen area is barely visible, it is possible that the Pannoramic® Scanner Software
for Research control software will analyze that area as an empty one.
MAY 13, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
Figure 67. Focus level and step size
Figure 68. Scan settings
SCANNING MODES AND SETTINGS
84