3D Histech PANNORAMIC SCAN RX User Manual page 123

PANNORAMIC® SCAN RX 1.0
For Slide scanning has finished and Scanning error has occurred you can define
the external software by entering the file path in the Application box, or by
browsing for it by clicking
If you define parameters in the Parameters field, it will pass them to the software
that it starts. If no parameter is defined, then the parameter will not be passed.
The default parameters are the following:
▪
For Slide scanning has finished: "<SLIDENAME>" – transfers the slide
name
▪
For Scanning error has occurred: "<ERRORTEXT>" – transfers the error
message
Notice:
Pannoramic® Scanner Software for Research control software can provide not only the
"<SLIDENAME>" but the path of the digital slide as well.
Run defines the window mode that the external application will start in. The
following window modes can be set:
•
Normal window
•
Minimized
•
Maximized
You can test whether the Scanning Error Occurred settings work by clicking
Caution!
If C:\ProgramData\3DHISTECH\SlideScanner\MessengerUserPreferences.xml is missing or
damaged, the External application call feature will not be able to read the address book,
therefore it will not operate. To solve this issue, the address book must be repaired or
created again.
MAY 13, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
.
SETTINGS AND SERVICES
.
122