3D Histech PANNORAMIC SCAN RX User Manual page 35

PANNORAMIC® SCAN RX 1.0
To insert and remove magazines
Warning!
Do not reach into the input/output stack movement area of the magazine, while magazines
are loaded/unloaded. The flaps (5) shown in Figure 9 must be closed during operation!
1. Remove magazine cover, before you insert magazines.
Caution!
Replace magazine cover, when magazine is not currently used, or is stored for a longer
period. The cover prevents soiling and mechanical damage.
2. Open the flap of the input stack (5) and put a magazine (1) into the input stack (4). The
magazine's rack (the back side of the magazine) (2) must contact with the guide rails with
its open side towards the scanner.
3. Slide down the magazine on the input guide rails until it rests on the guide pins or
magazines.
MAY 13, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
Figure 9. Inserting a magazine
OPERATING SLIDES AND MAGAZINES
34