Notes Regarding Operational Safety - 3D Histech PANNORAMIC SCAN RX User Manual

PANNORAMIC® SCAN RX 1.0

Notes Regarding Operational Safety

The below chapter of this User's Guide contains information and warnings of a kind that must be
followed by owner/operator personnel.
Warning and advisory symbols which are used on the base unit of the Pannoramic® SCAN RX and
in chapter 1.1.3 Warning and Information Labels
Warning!
Disconnect mains plug! Remember to unplug the power cord before you open the
Pannoramic® SCAN RX main unit for maintenance.
Crush hazard! There is crush hazard in the movement area of the slide insert during
operation. Make sure not to reach with your hands into the instrument to avoid the risk of
crushing your fingers. Please note that the digitizing process has to be interrupted and the
slide magazine moved via software to the output position before removing it.
The Pannoramic® SCAN RX, including any of its original accessory components, should not be
operated in any other way than described in chapter
Any of the following notes should be strictly observed:
Warning!
If operating the device other than specified by the manufacturer, the level of safety will
decrease.
Warning!
Insert the power cord plugs only into a grounding outlet. The protective action must not be
rendered ineffective by extension cables without protective conductor. The Pannoramic®
SCAN RX has a built-in protection which must not be rendered ineffective by extension
cables without protective (earth-ground) conductor.
MAY 13, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
NOTES REGARDING OPERATIONAL SAFETY
have the following meanings:
1.1.1 Intended Use.
9