PANNORAMIC® SCAN RX 1.0
Click Test run to check that barcode settings are correctly set. Click Reset barcode
exposition time to load default exposition time used for barcode reading.
Notice:
If the figure is not set correctly, or there is no barcode in the barcode area, the software will
display the following error message: "Barcode detection unsuccessful! There might be no
barcode present.".
o
Barcode reader library
▪
Select MIL barcode library or Embedded barcode library.
o
General Barcode settings
▪
Inverse barcode color
Activate to invert foreground and background colors of the barcode.
▪
Use barcode compensation
A compensation image is used during barcode reading.
▪
Grab new comp
Click this button to create a new compensation image for barcode.
Notice:
New compensation image for barcode can be recorded only if MIL is used for barcode
identification.
•
Barcode types
o
Linear
o
Stacked linear
o
Postal
o
Two-dimensional
•
Second barcode priority – The software is capable to read two barcodes at the same
time. If activated, the second barcode will be the barcode used for slide identification.
MAY 13, 2021
FOR RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES .
SETTINGS AND SERVICES
131