Hardware Installation; Installing The Smartswitch Remote Access Module; Connecting The Module's Cabling - Cabletron Systems SmartSwitch 9W006 Quick Start Manual

H I
ARDWARE NSTALLATION
This section provides instructions for:
• installing the 9W006/9W007 module in to a SmartSwitch 9000
• completing the module's cabling
In case you need to restart the module during installation, instructions are also included for
resetting the module.
I S
NSTALLING THE MART
The SmartSwitch Remote Access Module and the host SmartSwitch 9000 are
sensitive to static discharges. Use a grounding strap and observe all static
!
precautions during this procedure. Failure to do so could result in damage
to the SmartSwitch 9000 or the module.
CAUTION
1. The module fills two SmartSwitch 9000 slots. Remove the SmartSwitch panels that cover the
two slots into which the module will be installed. For proper airflow and cooling, cover any
empty slots.
2. Before installing the module into the chassis, ensure that the bottom and top plastic tabs are
unlocked.
3. Slide the module into the available slots making sure that the module is between the guides.
Take care that the module engages the backplane connectors properly.
4. Lock down the top and bottom plastic tabs at the same time, applying even pressure.
C M
ONNECTING THE ODULE
Installing the module into the SmartSwitch 9000 automatically completes its power supply and
SMB connections.What you will need to complete, though, is the Ethernet and PRI cabling. In
addition, U.S. and European installations need a Mod-Tap adapter for each PRI port.
We include an illustration of the 9W006-400. You may find this illustration helpful for locating the
module's Ethernet and PRI ports. Instructions for each cabling requirement follow the illustration.
S R A
WITCH EMOTE CCESS
' C
S ABLING
M
ODULE
I M
NSTALLING THE ODULE

Hardware Installation

9W006 and 9W007 9