Using The Nvram Switch - Cabletron Systems MicroMMAC-24E Installation Manual

Chapter 2: Controls and Indicators

2.5 USING THE NVRAM SWITCH

It is not necessary to remove the chassis cover from the
NOTE
MicroMMAC to gain access to the NVRAM switch.
To prevent the possibility of electrical shock, use only a
non-metallic tool when operating the NVRAM switch.
NVRAM (Non-Volatile Random Access Memory) stores user-entered
parameters such as community names, port configuration settings, and the
IP address. The NVRAM switch is accessible through the last lower
circulation vent on the right side panel (see Figure 2-2). To clear
NVRAM, perform the following steps:
Do not clear NVRAM unless you intend to reset the
!
MicroMMAC user parameters to the factory default settings.
CAUTION
1. Ensure that the MicroMMAC is powered-on.
2. Use a non-metallic tool to change the state of the NVRAM switch.
For example: Move the switch from one position to another.
3. Press the Reset button. The MicroMMAC reboots and returns all
user-entered parameters to the factory default settings.
Page 2-8 MicroMMAC Installation Guide