Axis Motors - YASKAWA YYR-1-06VXH25-A10 Operating And Maintenance Manual

Maintenance and inspection
9.6
For the all axis motors, there are holes for grease-leakage detection. Remove the screws
from the holes to check for grease leaking from the motor. For these procedures of each
axis, refer to figure "Positions of grease-leakage detection hole".
When grease leakage is detected, contact YASKAWA representative.
1 1 screw M4 x 6 mm* screw (Tighten-
ing torque: 0.75 Nm)
2 Grease-leakage check operation is
necessary for wall-, tilt-, and ceiling-
mounted, but not for floor-mounted
type.
3 Enlarged view shows the example of
floor-mounted type.
For the " * "parts, the screw whose head faces to the ground must be removed to check the
hole.
1 1 screw M4 x 6 mm* screw (Tighten-
ing torque: 0.75 Nm)
2 Enlarged view shows the example of
floor-mounted type.
Move the robot to make the either one of screws marked with "*" face to the ground and
remove it to check the hole.

Axis motors

Positions of grease-leakage detection hole (S-,L-axis)
Positions of grease-leakage detection hole (U-,R-axis)
-
9 59