Adjustable Working Area; Instructions For Installing The Mechanical Limit - YASKAWA YYR-1-06VXH25-A10 Operating And Maintenance Manual

Hide thumbs

Table Of Contents

Table of Contents

Technical data

6.4

The work area of the s-axis may be changed depending on the type of application.

If any modification is necessary, please contact the local YASKAWA branch office.

Item

S-axis working range

6.4.1

•

Mount the mechanical limit of S axis so that as shown in the figure "Components of the

S axis limit".

•

Fasten the dog on the S-head using 2 places M16 x 25 screws (Strength category 12.9).

Tighten the screws with a tightening torque of 206 Nm.

•

With a working area of ±180°, the stop must be mounted (as shown in the figure

"Components of the S axis limit").

•

The stop can be mounted at 30° intervals. To avoid a mechanical interference from stop

duplication (eg ± 30°, ± 150°), install the mechanical stop as shown in the following table

Fig. 6-3: "Adjustable angle for the S-axis limit".

NOTICE

 Always use the specified components when installing the S-axis limit

 Switch OFF the supply voltage before you start mounting.