Select Trigger Source; Restore The Factory Default Settings - Cal Power IT-M3400 Series User Manual

Table of Contents

series instrument. You can select GPIB, USB, RS-485, RS-232, CAN or LAN

interface based on personal requirement.

1. Press the composite keys [Shift]+[P-Set](System) to enter the System

2. Rotate the knob to select I/O Config and press [Enter] to confirm.

3. Rotate the knob to select the communication interface and press [Enter] to

4. Press [Esc] key to exit.

7.4.5 Select Trigger Source

This series Power supply supports the following trigger sources:

•

The procedures to set the menu item are as follows.

1. Press [Shift]+[P-set] （System）to enter the system menu interface.

2. Use left and right keys or rotate the knob to select Trig Source and press

3. Rotate the knob to adjust the parameter KeyPad or Bus and press [Enter].

This menu item is used to restore the factory default settings. The procedures to

set the menu item are as follows.

1. Press [Shift]+[P-set](System) to enter the System menu interface.

2. Rotate the knob to select System Reset and press [Enter].

3. Rotate the knob to select Yes or No and press [Enter] to confrim.

menu interface.

confirm, and also set the parameters of interface.

2.6 连接接口

Please refer to

communication interface parameter.

KeyPad: Default value, Select the front panel [Shift]+[On/Off] (Trigger)

button as the trigger source.

Bus: Select the remote interface command as the trigger source, such as

the *TRG command.

[Enter] to make the parameter in modification.

•

No: default value, indicates cancels this menu setting.

•

Yes: indicates the instrument restores the factory default settings.

System-Related Functions

for the detailed description of each

Table of Contents