Set Output Parameters - Cal Power IT-M3400 Series User Manual

Error Messages
Wait For Master
EEProm Failure
Turning the POWER Switch Off
Flip the POWER switch to the ( O ) side to turn the instrument off. When it is
turned off, the instrument interface will prompt "Power Down", and the
instrument will store the setting information before shutdown in the group 1 non-
volatile memory.
After you turn the POWER switch off, wait at least 10 seconds after the fan
stops before you turn the POWER switch back on. Turning the instrument on
too soon after you turn it off can cause damage to the inrush current limiter
circuit, as well as reduce the life of components such as the POWER switch and
the internal input fuses.

3.2 Set output parameters

The voltage value, current value and power value can be programmed, which
can be set to different parameters within the specification range based on cus-
tomer requirements. This can meet various test requirements of the customer.
After the user selects the Running mode on the front panel, the instrument inter-
face displays the parameters to be set under the existing running mode, and the
cursor flashes for prompt. Or, press the knob to set parameters.
The pressing knob is introduced below.
•
The instrument takes approximately 30 seconds to initialize before it is ready
for use.
Rotate the knob to set the data value at the cursor. The set value is in-
creased with crosswise rotation, and decreased with counterclockwise rota-
tion. When the knob is rotated to set parameters, automatic carrying is made
Copyright © Itech Electronic Co., Ltd.
Description
The instrument is waiting the
master.
EEProm is broken.
Getting Started
40