Battery Charging/Discharging Test Function - Cal Power IT-M3400 Series User Manual

1. Select the List file to be run in the Recall List.
2. In the List function setting interface, select "Run", and press [Enter] key to
3. Press [On/Off] to turn on the instrument output.
4. Conduct trigger based on the trigger mode set in the system menu, such as
Stop running and re-running
During the running of List file or when the running is finished, the interface dis-
plays END. Press [Shift]+[I-set](Function) composite key, and the instrument
interface displays the running state control interface of the existing file. The user
can press Stop to stop existing test and turn off the List function. Or, press
Reset to restart a new test.

5.2 Battery Charging/Discharging Test Function

This series provides the battery charging and discharging test function . The
user can edit 10 test files, and can recall these files to execute test.
Bat- Battery test function
tery
Run Turn the battery test function on.
Recall battery test file.
Recall
Recall
Batt=1/10
Edit the battery charging/discharging test file.
Edit
Edit File=
1/10
confirm that the instrument automatically returns to the main interface and
waits for trigger.
0.000V 0.0000A
0.0W WTG
front panel trigger mode. Press [Shift]+[On/Off] (Trigger) key for triggering,
and the instrument would output based on set sequence.
12.000V 5.0000A
100.00W RUN
Select battery test file number, the total of file number is ten, when
the selected file dose not exist, empty file will be prompted.
Batt Mode
Disch/Charge V
Disch/Charge I
Disch/Charge
Time
Cut Off V
Cut Off I
Cut Off Q
Select the test file, the total of file number is ten.
Copyright © Itech Electronic Co., Ltd.
Enter the test file viewing interface,
parameter setting shall be consistent with
parameter in Edit menu. When recall the
files, the parameters can only be viewed and
can't be modified.
Advanced Function
54