Cal Power IT-M3400 Series User Manual page 61

I_Lim –
V_High
V_Low
End State
Repeat
Edit Edit the step parameters of List file
Step
Current/
Voltage
Slope
Time
Next
Insert Insert one step and set the step number to insert one
Step step before the step.
Add Add one step and set the step number to add one step
Step after the step.
Copyright © Itech Electronic Co., Ltd.
Advanced Function
set when the List running
mode is CV prioritized.
High limit value of negative
current, which needs to be
set when the List running
mode is CV prioritized.
High limit of voltage range,
which needs to be set
when the List running mode
is CC prioritized.
Low limit of voltage range,
which needs to be set
when the List running mode
is CC prioritized.
Set the running state after
the List execution is
finished:
•
Normal: Directly stop
the waveform output
after the execution is
finished;
•
Last: Keep the last
waveform unchanged
after the execution is
finished.
Set the number and range
of running cycles of the List
file: 1–65535
Current value/voltage value
Based on the selected run-
ning mode display, set volt-
age value under the CV
mode, and set current val-
ue under the CC mode.
Slope value, with setting
range of: 0.001S-3600S
Duration, with setting range
of: 0.001S-3600S
Select whether to edit the
next step: Yes/No
50