Local/Remote Mode Switch; Basic Operation; Set The Beeper Status - Cal Power IT-M3400 Series User Manual

Table of Contents

2. Rotate the knob and enter the number 1 to 10 and set the recall location,

7.3 Local/Remote Mode Switch

The instrument provides both local and remote operation modes. The default

mode is local operation mode.

•

This chapter describes the basic functions and features of the instrument. Div-

ided into the following sections:

The user can turn the instrument beeper sound on or off according to personal

requirement.

•

Operation procedures:

1. Press the composite keys [Shift]+[P-Set](System) to enter the System

2. Rotate the knob to select Beep and press [Enter] to confirm.

3. Rotate the knob to select On or Off and press [Enter] to confirm.

4. Press [Esc] to exit menu interface.

•

first line: display the location of parameter.

•

sencond line: display the value of parameter. these parameters are

different under different mode. The above example takes CC priority as

example.

press [Enter] to recall the parameters.

Local operation mode: Use the front panel keys to control the power system.

Remote operation mode: The power system is connected to PC, and the

user uses the software in PC to control the power system remotely. During

remote control operation, the remote symbol "Rmt" is displayed. All panel

keys, except for the [On/Off] and [Shift]+[Link](Local) keys are locked.You

can press [Shift]+[Link](Local) to switch the remote control to local control.

The mode modification will not affect the output parameters of the power

system.

On status: A beeper sound produced when the front panel key is pressed.

Default status is on.

Off status: The beeper is disabled.

menu interface.

At this point, the beeper status takes effect immediately.

System-Related Functions

Table of Contents