Gpib Interface - Cal Power IT-M3400 Series User Manual

2. Press the composite keys [Shift]+[P-Set](System) to enter into the system
3. Use left and right keys or rotate the knob to select I/O Config and press
4. Use left and right keys or rotate the knob to select USB and press [Enter]
5. Use left and right keys or rotate the knob to select TMC or VCP, after select
6. After finishing the setting, press[Esc] to exit.

2.6.2 GPIB Interface

When the optional interface card is a GPIB interface (IT-E1205), you need to
know the following.
Each device on the GPIB (IEEE-488) interface must have a unique number
address between 0 and 30. Your computer's GPIB interface card address must
not conflict with any instrument on the interface bus. This setting is nonvolatile;
it will not be changed by power cycling or *RST. The figure below shows a
typical GPIB interface system.
You can change the GPIB address in the system menu. The operation steps
are as follows.
1. Refer to the GPIB connection diagram, Connect the power supply and the
2. Press [Shift]+[P-Set](System) to enter into the system menu interface.
3. Use left and right keys or rotate the knob to select I/O Config and press
4. Use left and right keys or rotate the knob to select GPIB and set GPIB
menu interface.
[Enter] key to confirm.
key to enter the usb setting menu.
and press [Enter] to confirm.
•
TMC: USB_TMC interface
•
VCP: virtual serial port. Select this type, you need to install the
corresponding driver (download from the ITECH website or contact
ITECH agent). The device manager of PC will display 'Prolific USB-to-
Serial COM Port' after installing.
computer using a IEEE-488 bus.
[Enter] key to confirm.
Address, press [Enter] key to confirm.
Copyright © Itech Electronic Co., Ltd.
Inspection and Installation
25