Table of Contents
Advertisement
3
Getting Started
♦ Power-on the Instrument
♦ Set output parameters
♦ Use the Front Panel Menu
♦ Output On/Off Control
3.1 Power-on the Instrument
A successful selftest indicates that the purchased power product meets delivery
standards and is available for normal usage. Before operation, please confirm
that you have fully understood the safety instructions.
When you turn the POWER switch on for the first time after purchase, the
instrument starts with its factory default settings. Each time thereafter, the
instrument starts according to the setting that you selected as outlined in
Set the Power-on State
Precautions
To prevent electric shock and damage to the instrument, please observe the
following precautions.
•
•
•
•
.
Before connecting power cord, be sure to confirm that the power voltage
matches with the supply voltage.
Be sure to connect the main power socket to the power outlet with
protective grounding. Do not use terminal board without protective
grounding.
Ensure that the input electrodes are either insulated or covered using
the safety covers provided, so that no accidental contact with lethal
voltages can occur.
If you notice strange sounds, unusual odors, fire, or smoke around or
from inside the instrument, flip the POWER switch to the (O) side to turn
the instrument off, or remove the power cord plug from the outlet. The
detachable power cord may be used as an emergency disconnecting
device. Removing the power cord will disconnect AC input power to the
unit.
Copyright © Itech Electronic Co., Ltd.
Getting Started
7.4.2
38
Advertisement
Table of Contents
