Cal Power IT-M3400 Series User Manual page 39

notation applies as for the IP Address. When a client IP address is on a
different subnet, all packets must be sent to the Default Gateway.
– Gateway: This value is the IP Address of the default gateway that allows
the instrument to communicate with systems that are not on the local
subnet, as determined by the subnet mask setting. The same numbering
notation applies as for the IP Address. A value of 0.0.0.0 indicates that
no default gateway is defined.
– DNS1: This field enters the primary address of the server. Contact your
LAN administrator for server details. The same numbering notation
applies as for the IP Address. A value of 0.0.0.0 indicates that no default
server is defined.
DNS is an internet service that translates domain names into IP
addresses. It is also needed for the instrument to find and display its
hostname assigned by the network. Normally, DHCP discovers the DNS
address information; you only need to change this if DHCP is unused or
not functional.
– DNS2: This field enters the standby address of the server. Contact your
LAN administrator for server details. The same numbering notation
applies as for the IP Address. A value of 0.0.0.0 indicates that no default
server is defined.
The operation steps to configure are as follows.
1. Press [Shift]+[P-Set] (System) to enter into the system menu interface.
2. Use left and right keys or rotate the knob to select I/O Config and press
[Enter] key to confirm.
3. Use left and right keys or rotate the knob to select LAN and press [Enter]
key to confirm.
4. Use left and right keys or rotate the knob to select Lan Config and press
[Enter] key to confirm.
The first displayed menu item IP Mode is to configure the instrument
address.
5. Press [Enter] key to confirm. This parameter is in modification.
•
Auto: automatically configure the addressing of the instrument;
•
Manual: manually configure the addressing of the instrument.
If Manual is selected, set the parameters such as IP Addr and Sub Net.
When you set the IP address and the Gateway, if present display is
one-digit as 192.168.200.1, you can press right and left keys to
display 001 and modify the 1.
6. After setting, press [Esc] to exit.
Copyright © Itech Electronic Co., Ltd.
Inspection and Installation
28