View The System Information; Measuring The Dut Temperature - Cal Power IT-M3400 Series User Manual

7.4.8 View the System Information

This menu item is used to view the system information of the instrument. The
procedures to view the system information are as follows.
1. Press composite keys [Shift]+[P-Set](System) to enter the System menu.
2. Rotate the knob to select System Info and press [Enter] to confirm.
3. Rotate the knob and view the system information.
4. Press [Esc] to exit.

7.5 Measuring the DUT Temperature

This series instrument features temperature measuring terminals (Temp, GND),
is used to measure the DUT temperature. The operation procedures as
following:
1. Connecting the test line
2. Observe the information
Name
Model
ArmVer
InvDspVer
FpgaVer
CommVer
SN
Mac
Last Cal
Start Time
a. Loosen the screws of the measuring temperature terminals, and insert
the thermocouple. Re-tighten the screws.
b. Connecting the other end of thermocouple to DUT.
a. Press the composite keys [Shift]+[P-set](System) to enter the system
menu.
b. Rotate the knob to select the External Meter and press [Enter] to
confirm.
c. The DUT temperature and total historical regenerative power are
displayed on screen.
1：UUT Temp
Copyright © Itech Electronic Co., Ltd.
System-Related Functions
Description
The instrument model
The control board version
The DSP version
The Fpga version
The communication board version
The serial number
The firmware address
Last calibration date
Instrument running time
80