Trigger Operation; Menu Operation; Menu Structure - Cal Power ITech IT6860B Series User Manual

Save operation:
Set the desired Voltage and Current value
Press the (Shift) +
confirm.
Recall operation:
Keep group setting unchanged, press
where the settings you want to recall are stored.
Group Concept：
When storage amount exceeds 9,you have to enter into menu and select MEM item to
change the group set. Meanwhile, to recall a pre-stored parameter should be coordinated
with correct group set. For example, if you want to recall parameters which are stored in
memory location from 10 to 19, then MEM should be set to group 1.
To change group set:
(1) Press (Shift) +
Enter
SET,press
(2) Press to select MEM,enter a numerical value,press

5.9 Trigger operation

IT6860B series power supply supports two different trigger modes Manual and Bus.
Configure one of the trigger sources before performing trigger operation.
This operation is often used with list operation. It provides a trigger signal to start running a
list file. During the process of running a list file, trigger button
blinking until finished.

5.10 Menu Operation

1.

Menu structure

Press (Shift) +
through the menu list and press
Esc button to return to the higher level menu and to quit the menu setting.
MAX
Set the Maximum Voltage
VOLT
SYST
SET
P-MEM
(RESET)
P-OUT
(OFF)
Recall
+number 1 to 9 to assign a memory location. Press
I-set I-set
button to enter the menu,press
to confirm.
I-set I-set
(Menu) to enter menu mode. Use the
Enter
Reset
Keep
OFF
Keep
Recall
+number 1 to 9 to select the memory location
to select a item and view the parameters. Press
Return to the factory default setup value
"Remembers"
parameters of power supply (voltage, current
settings...) before power was turned off. The next
time you power up the unit, the parameters will be
recalled automatically.
Set the Power to OFF state after power up.
"Remembers" and restores the power ON/OFF
state of power supply before power was turned
off. The next time you power up the unit, the
19
IT6860B User manual
button to select SYST
Enter
to confirm.
Enter
(Trigger) will keep
, or knob to scroll
and restores the
用户使用手册
Enter
to
operating